TouchMotion AWD Programmer
TouchMotion AWD Programmer
TouchMotion AWD Programmer
TouchMotion AWD Programmer
TouchMotion AWD Programmer
TouchMotion AWD Programmer
TouchMotion AWD Programmer
TouchMotion AWD Programmer
TouchMotion AWD Programmer
TouchMotion AWD Programmer

TouchMotion AWD Programmer

HVA-901

Regular price USD $749.00

/
Shipping calculated at checkout.

The TouchMotion AWD Programmer from HPA Motorsports is a plug and play device compatible with Gen 1 Haldex 4-motion controllers.

The TouchMotion AWD Programmer from HPA Motorsports is a plug and play device compatible with Gen 1 Haldex 4-motion controllers.

Designed to be fully compatible with both OEM or aftermarket installed Haldex 4-motion differential controllers, the Touch Motion plugs inline and hands control of the rear end behavior over to the driver.

HPA's TouchMotion AWD Programmer consists of three main components. A trunk mounted Control Unit, a Cable to connect the new controller inline, and a wireless Touch Screen Interface.

The Touch Screen Interface features a live interactive display that tells the driver how much torque is being transmitted to the rear wheels at any time and offers access to a number of basic and advanced configurations. The touch screen is merely the user interface for the TMAP system and does not need to be present to run the controller as the controller will operate under the last user settings inputted.

Through the touch of the screen, drivers can select not only the preset operating modes of the differential such a Stock, Economy, Sport or Competition, they can go beyond with Dynamic and Race-Speed where they can individualize the profile based on driving habits and needs.

Under Race-Speed, drag racers can digressively or progressively adjust rear engagement. Example; when launching AWD vehicles from prepared surfaces, typically some front wheel spin is desired to better facilitate engine acceleration prior to full rear wheel power transfer avoiding engine bog. As the speed down the track increases, the rear differential engagement can be scaled straight back to reduce drag and increase top speed.

Under Dynamic, drivers can configure which modes to toggle between and what the transitions will be triggered by. Example, set in economy mode for daily commuting, the driver wishes to toggle straight into an aggressive full torque transfer configuration and back when overtaking a vehicle may be required.

Within advanced settings, over-steer compensation can be reduced for drivers that wish to enable more drift tendency, and engagement of differential under braking can be toggled on or off depending on driving style, comfort, or usage habits.

HPA has developed a tool that will allow the driver to tune the drivetrain to meet their specific needs.

The left graph represents all preset modes performing an acceleration run from 40mph to 110mph. The right graph represents Stock, Competition, and Race Speed; the top line represents overall wheel horsepower, while the lower lines differentiate between front wheel horsepower and rear wheel horsepower.
 

Documentation

Download TMAP Quick Start Guide

Download TMAP Features and Functions

Download Performance Suite Guide

 

Applications:

Year Make
Model Generation
2004 Volkswagen R32 MK4
1998 - 2006
Audi
TT
8N

HPA branded products carry a one year warranty against manufacturer's defects on all major, non-consumable, components.  Damaged caused by incorrect installation, wear and tear, abuse, misuse, racing, collision, foreign particles, etc., will NOT be covered by warranty.

Warranty is offered to original purchaser only and is not transferable.

HPA Motorsports will not be liable for incidental, consequential, indirect, special, or punitive damages of any kind.  HPA’s entire liability shall be limited to replacement or repair of the damaged parts at HPA’s option. 

Labour and freight costs associated with warranty repair or replacement are NOT covered.

To maintain validity of warranty, factory recommended maintenance schedule and manufacturer’s Technical Service Bulletins (TSB’s) must be adhered to and documented.

In addition to the above, the HPA FT/FTX series Turbo packages for VR6 motors have the following conditions:

Components covered by warranty include:

  • Turbochargers
  • Exhaust Manifold
  • Downpipe
  • Catalysts
  • Exhaust System
  • Intake Manifold
  • Silicone Plumbing
  • Intercoolers
  • Fuel Pump
  • Fuel Injectors
  • Brake Calipers
  • Haldex Controller

Components NOT covered by warranty include:

  • Clutch
  • Gearbox
  • Brake Pads & Brake Rotors

Any claims of defect in workmanship must be repaired at HPA Motorsports' facility located in Langley, Canada. Should the damage be determined to be a direct result of the workmanship of HPA Motorsports, labor costs for HPA Motorsports to complete repairs at our own facility will be included in the warranty repair. In certain circumstances, at the sole discretion of HPA Motorsports, permission may be granted for repairs to be completed at an HPA authorized facility at a pre-approved labor rate.

HPA Motorsports will not be liable for incidental, consequential, indirect, special, or punitive damages of any kind. HPA’s entire liability shall be limited to replacement or repair of the damaged parts at HPA’s option.

To maintain validity of warranty, in addition to the factory recommended maintenance schedule, the following services must be adhered to and documented according to the prescribed schedule:

Break In period: engine speed is not to exceed 5500 RPM, and absolutely NO standing starts are to be performed 1000 km / 620 miles
Mass Air Flow meter – Clean 5000 km / 3100 miles
Mass Air Flow meter – Replace 20,000 km / 12,500 miles
Engine Oil (Motul Xcess / 8100 5w40) & Filter – Replace 5000 km / 3100 miles
Haldex Fluid & Filter – Replace 10,000 km / 6000 miles

Any claims of defect in workmanship must be repaired at HPA Motorsports' facility located in Langley, BC Canada.  Should the damage be determined to be a direct result of the workmanship of HPA Motorsports, labor costs for HPA Motorsports to complete repairs at our own facility will be included in the warranty repair. 

For remote customers, in certain circumstances, at the sole discretion of HPA Motorsports, permission may be granted for repairs to be completed at an HPA authorized facility at a pre-approved labor rate.

 

Should you experience any issues with your items, please contact HPA Motorsports for technical assistance using the form below or by calling 604-888-7274 prior to engaging in any repair procedure.  Failure to follow the advice of our technical support staff may cause undue harm that will not be covered by warranty.

Customer Reviews
5.0 Based on 9 Reviews
5 ★
100% 
9
4 ★
0% 
0
3 ★
0% 
0
2 ★
0% 
0
1 ★
0% 
0
Write a Review

Thank you for submitting a review!

Your input is very much appreciated. Share it with your friends so they can enjoy it too!

Filter Reviews:
J
10/25/2021
Jud
United Kingdom United Kingdom

Excellent product

Its transformed the drivetrain in a much better way thanks

AB
10/12/2021
anthony b.
United Kingdom United Kingdom

AUDI TT Hill and Sprint car

The controller is very easy to fit less than 20 mins had it connected routed and control unit fitted Touch screen was adapted and fitted to a gopro mount which was screwed to interior flat surface I set it in RACE MODE for its first sprint meeting and found that i was still having to switch traction control off to stop wheel spin even though i run slicks It didn't stop me from setting new PB's on both days Overall very impressed I'm sure with some tweaking i can adjust it for most courses i will run next year

JS
04/02/2021
Jan S.
New Zealand New Zealand

Amazing upgrade.

I installed this controller in my relatively stock R32, which in its self is an easy process. The way the dynamics of the car have been transformed is incredible. If you are an enthusiastic corner fiend this is hands down the best thing you can do for the car. The ability to reduce oversteer compensation is my favourite bit. Great product.

J
01/03/2020
Jacques

Magic part

I have the TouchMotion for about one year. I think it's the best part you can mount on an S3 8L. The handling of the vehicle is really much better! Thanks HPA and sorry for my bad english! See you from Switzerland ;-) Jacques

W
07/23/2018
Weldon

Awesome upgrade!

This is an awesome upgrade! The car has so much more control. All the functions are great. Took less than 30 minutes to install. This is a great addition to anyone's upgrade list with a Gen 1 haldex.